nebuchabi
Hi!
I have the following command on a button:
deck left eq_mid -0.05 & deck right eq_mid +0.05
Now I would like to make the change (here by 0.05) dependent on which other button is pressed. To do this, I have assigned 3 buttons with:
set '$eqdelta' 0.05
set '$eqdelta' 0.10
set '$eqdelta' 0.20
and the following command on another button:
deck left eq_mid "get_var '$eqdelta'" &
deck right eq_mid "get_var '$eqdelta'"
Unfortunately this does not work! How can I implement the negative values?
And then a knob should not be able to be turned further than the center (=0.5).
param_greater "deck right eq_mid" ? deck right eq_mid 0.5 : nothing
unfortunately does not work either
Does anyone have an idea?
I have the following command on a button:
deck left eq_mid -0.05 & deck right eq_mid +0.05
Now I would like to make the change (here by 0.05) dependent on which other button is pressed. To do this, I have assigned 3 buttons with:
set '$eqdelta' 0.05
set '$eqdelta' 0.10
set '$eqdelta' 0.20
and the following command on another button:
deck left eq_mid "get_var '$eqdelta'" &
deck right eq_mid "get_var '$eqdelta'"
Unfortunately this does not work! How can I implement the negative values?
And then a knob should not be able to be turned further than the center (=0.5).
param_greater "deck right eq_mid" ? deck right eq_mid 0.5 : nothing
unfortunately does not work either
Does anyone have an idea?
Inviato Sat 25 May 24 @ 11:05 pm
locoDog
The only param type eq_* accepts is a value [either absolute or relative, a number or a ± number] and that can be expressed as a float 0.0-1.0 or as a percent 0-100%
It does not accept an action as param.
To pass a variable you do this
to pass the value as absolute
to pass as positive relative
to pass as negative relative
Your query is incomplete, you have no value to compare against.
param_bigger 0.5 `eq_mid` ?
[is mid higher than 0.5]
It does not accept an action as param.
To pass a variable you do this
to pass the value as absolute
get_var $eqDelta & param_cast & eq_mid
to pass as positive relative
get_var $eqDelta & param_cast relative & eq_mid
to pass as negative relative
get_var $eqDelta & param_multiply -1 & param_cast relative & eq_mid
Your query is incomplete, you have no value to compare against.
param_bigger 0.5 `eq_mid` ?
[is mid higher than 0.5]
Inviato Sat 25 May 24 @ 11:47 pm
nebuchabi
Hi!
Great! That works! I've been looking for it for hours! Thank you so much!
Great! That works! I've been looking for it for hours! Thank you so much!
Inviato Sun 26 May 24 @ 3:25 pm