SBDJ
Good afternoon :)
Came across a small issue with the mapping of the Performer.
If you have stems EQ enabled and your hardware EQs aren't set centre before starting Virtual DJ (or switching to stems EQ) then the EQ change persists until you go back to frequency EQ and move all affected EQ pots to reset them.
Not a big pain, after all Shift+PFL is mapped to switch EQ modes like Serato, but I have seen a couple of people complain about audio issues in the past so thought it worth mentioning as this could be a cause, especially since it's not something you can see in the UI.
I did try to switch the EQ mode and reset the EQ in VDJ through mapping a custom button, but it seemed to require actual hardware input to resolve. I didn't dig into it any further.
Obviously in Serato such settings don't persist, so stems EQ isn't enabled at startup. This means it's a conscious choice to turn it on, and thus easily becomes user error.
Came across a small issue with the mapping of the Performer.
If you have stems EQ enabled and your hardware EQs aren't set centre before starting Virtual DJ (or switching to stems EQ) then the EQ change persists until you go back to frequency EQ and move all affected EQ pots to reset them.
Not a big pain, after all Shift+PFL is mapped to switch EQ modes like Serato, but I have seen a couple of people complain about audio issues in the past so thought it worth mentioning as this could be a cause, especially since it's not something you can see in the UI.
I did try to switch the EQ mode and reset the EQ in VDJ through mapping a custom button, but it seemed to require actual hardware input to resolve. I didn't dig into it any further.
Obviously in Serato such settings don't persist, so stems EQ isn't enabled at startup. This means it's a conscious choice to turn it on, and thus easily becomes user error.
Inviato 2 days ago @ 11:11 am