Hardware Manuals


AKAI - LPD8  

Controlli




1 PROGRAM
Use this button to enter the Program Selection mode. When selected (buttons 2 to 4 are off), use the Pads [5] 5 to 8 to select one of the 4 available Programs. The default mapping is based on Program 1, so make sure Pad 5 is turned on.
2 PROG.CHNG
Use this button to enter the Page/mode selection (led will be lit). Then use Pads 1 to 8 to select one of the pre-defined Pads Pages of VirtualDJ. You can change the default Pages by selecting a different pre-selected Page. See Pad Page Assignment in VirtualDJ Manual
3 PAD
Use this button to select the Pads mode. In this mode Pads 1 to 8 trigger the Pad buttons of the selected Pads page
4 CC
Use this button to select the CC mode. In this mode Pads 1 to 8 become velocity Pads, and offer the same action as the 8 Knobs [6]
5 PADS 1-8
If the device is in PAD mode, use these buttons to trigger the assigned action of Pad 1 to 8 of the selected Pads Page in VirtualDJ
6 KNOBS 1-8
Regardless the mode the device is (PAD, CC, PRG), use these knobs to trigger the related action of Pad 1 to 8 of the selected Pads Page in VirtualDJ.
E.g. if the Sampler Page is selected, the knobs will control the volume of the Pad Samples.


PAD PAGE SELECT & ASSIGN


The default mapping offers the ability to select a different page/mode for the 8 Pads.
  • Press the PROG.CHNG button
  • Press Pad 1 to 8 to select the pre-defined Pads page
  • Press the PAD button to return to normal operation


By default Pads 1 and 2 will load the special STEMS (2 Decks) and STEMS (1 Deck) Pad pages (available only when the LPD8 is connected), and Pads 3 and 4 will load Hotcues and Sampler Pages.



The pre-defined Pads Pages can be changed and assigned to a different Page. See further details at https://www.virtualdj.com/manuals/virtualdj/interface/decks/decksadvanced/pads.html#controller

Setup Avanzato