- Hardware Manuals Index
- Numark Index
- DJ2GO2 TOUCH
- iDJ Live II
- Mixdeck Express
- Mixdeck Quad
- Mixtrack 3
- Mixtrack Edge
- Mixtrack II
- Mixtrack Platinum
- Mixtrack Platinum FX
- Mixtrack Pro
- Mixtrack Pro 3
- Mixtrack Pro FX
- Mixtrack Pro II
- Mixtrack Quad
- NDX 500
- NDX 800
- NDX 900
- NS6 II
- NS7 II
- NS7 III
- NV II
- PartyMix Pro
The lower 4 PADs (27) of the Mixtrack Quad offer Loop, Sampler and HotCues controls depending on the selected mode
Hold SHIFT down and then press the 1st PAD from left to set the lower PADs to Loop mode. The small orange led right below the 1st PAD will be lit to indicate the selected mode.
Press the 1st PAD to set a Loop In (Entry) point and then press the 2nd PAD to set the Loop Out (Exit) point and trigger a manual loop.
If a Loop is enabled press the 1st or 2nd PADs to set the Jogwheel to Loop In or Loop Out Adjust mode and then use the jogwheel to fine adjust the Entry and Exit points of the Loop. The Leds of the PADs will blink to indicate the selected mode.
Use the 3rd PAD to exit the Loop (if triggered) or trigger the last enabled Loop (re-loop).
Press the 4th PAD to half the size of the Loop or hold down SHIFT and then press the same PAD to double its size.
Hold SHIFT down and then press the 2nd PAD from left to set the lower PADs to Sampler mode. The small orange led right below the 2nd PAD will be lit to indicate the selected mode.
Each one of the 4 lower PADs (27) will trigger a Sample from the selected Bank of VirtualDJ. If the selected bank has less than 5 samples (slots), both sides of the Mixtrack Quad will control the same samples. If a bank has more than 4 samples (slots), the left side of the Mixtrack Quad will control samples 1 to 4 and the right side samples 5 to 8.
Hold SHIFT down and then press the 4th PAD from left to select and load the next available Sampler Bank.
Note. The Mixtrack Quad offers 16 different colors for the Leds of the PADs, and those will tend to display the assigned color of each Sampler slot.
Hold SHIFT down and then press the 3rd PAD from left to set the lower PADs to HotCues mode. The small orange led right below the 3rd PAD will be lit to indicate the selected mode.
Each one of the 4 lower PADs (27) assigns a Hot Cue Point (1 to 4) or returns the track to that Hot Cue Point. When a Hot Cue Button is unlit, you can assign a Hot Cue Point by pressing it at the desired point in your track. Once it is assigned, the Hot Cue Button will light. To return to that Hot Cue Point, simply press it.
Hold SHIFT (18) down and then press the 4th PAD from left to enter the Delete HotCue mode. The Leds of the 4 Pads will be lit red (if a HotCue is assigned). Press the Pads to delete its assigned HotCue.
Hold SHIFT and then press the 4th PAD to return to the HotCues mode.
If no HotCue point is assigned, the Pads will not enter the Delete HotCue mode. When the pads are in Delete HotCues mode, the 4th PAD will be lit orange as an indication of this mode.
Rear & Side Panels