Hardware Manuals


Numark - NS4FX - Layout  

FRONT & REAR PANELS





KEY

DESCRIPTION

41 HEADPHONES SOCKET
Connect your Headphones using a 1/4" or/and a 1/8" cable or adapter. The Volume of the Headphones channel is controlled from the top panel of the unit
42 CROSSFADER ASSIGN
Assign each deck to the left (A) or the right (B) side of the crossfader. Put the switcher on the middle position (Off) if you want to disable the crossfader for one or more decks
43 MIC2 INPUT
Connect a Microphone * using a 1/4" cable or adapter.
44 MIC2 LEVEL
Control the volume of MIC2 input
45 MIC2 TONE
Apply a simple single band EQ on MIC2 input
46 POWER
Connect the provided PSU and press the POWER button to turn on the unit
47 USB
Connect the NS4FX with a USB port of your computer, using the provided USB cable
48 MASTER OUTPUT
Connect your amplifier or amplified speakers using proper XLR cables. The Level of this Output is controlled from the top panel of the unit
49 BOOTH OUTPUT
Connect a second amplifier or another set of amplified speakers using proper RCA cables. The Level of this Output is controlled from the top panel of the unit
43 AUX INPUT
Connect a device that provides "Line level" audio signal. The Level of this Input is controlled from the top panel of the unit
43 MIC1 INPUT
Connect a Microphone * using a 1/4" cable or adapter. The Level of this Input is controlled from the top panel of the unit



* Note : The Microphone Inputs along with the AUX input are directly routed to the Master Output of the NS4FX. The inputs are not available in the USB Audio Interface, therefore they cannot be included in the Audio Setup nor can be recorded directly. However, recording your mix along with the Microphone Input is possible via Record LoopBack





For further Technical features and specifications, visit

Numark NS4FX
Product's Page







Hardware Integration Department
2022 - ATOMIX PRODUCTIONS



Reproduction of this manual in full or in part without written permission from Atomix Productions is prohibited.