Hardware Manuals


Pioneer DJ - DDJ-REV5 - Layout  

REAR PANEL






  1. MASTER OUT1: Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers. The level of this output is controlled by the MASTER LEVEL knob (10) at the top panel.

  2. MASTER OUT2: Master signal output connectors (RCA – Unbalanced). Use it to connect with another mixer, or consumer grade amplifier. The level of this output is controlled by the MASTER LEVEL knob (10) at the top panel.

  3. BOOTH OUT: Booth signal output (TRS – Balanced). The level of this output is controlled by the BOOTH LEVEL knob (11) at the top panel. Use it to connect your booth speakers, or an amp that needs different sound output level than master output.

  4. USB A/B: Use standard USB-C cables to connect the DDJ-REV5 with your computer. Select USB A or USB B from the top panel Source selectors to control VirtualDJ Decks. You can connect up to computers at the same time (back-to-back DJs). When one side is switched to the other computer from the top switches, the Decks (1,3 or 2,4) will show a MUTE text next to their Titles

  5. AUX INPUT: Use standard RCA cables to connect an auxiliary audio source. The level of this input will be controlled by the AUX LEVEL knob (62) at the front panel and its signal will be directly routed to the Master output of DDJ-REV5.
    Note : This input is not part of the USB Audio interface, cannot be added to the Audio Setup of VirtualDJ, but can be recorded along with your mix.

  6. MIC 2 INPUT: Connect a mic on the DDJ-REV5 mixer. You can use only a Jack (TRS) connector. The output volume of this input can be controlled from the MIC 1 LEVEL knob (54) at the front panel
    Note : This input is not part of the USB Audio interface, cannot be added to the Audio Setup of VirtualDJ, but can be recorded along with your mix.

  7. MIC 1 INPUT: Connect a mic on the DDJ-REV5 mixer. You can use XLR or Jack (TRS) connectors. The output volume of this input can be controlled from the MIC 2 LEVEL knob (54) at the front panel
    Note : This input is not part of the USB Audio interface, cannot be added to the Audio Setup of VirtualDJ, but can be recorded along with your mix.

  8. POWER SWITCH: Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.

  9. DC INPUT: Connect the supplied PSU to this USB-C socket


Frontale