Hardware Manuals


Reloop - Beatpad - Layout  

EFFECTS & LOOPS



  1. FX ON. Use this button to enable/disable the selected effect.

    Hold SHIFT down and then use the left FXON button to trigger the selected Video Transition and the right FXON button to trigger the selected Master Video Effect.

  2. FX SELECT. Use this encoder to select an Effect for this deck. Push the encoder to open/close the GUI of the selected effect.

    Hold SHIFT down and then use the left FX SELECT encoder to select a Video Transition and the right FX SELECT encoder to select a Master Video Effect.
    Hold SHIFT down and then push the left encoder to open/close the GUI of the selected Video Transition and the right encoder to open/close the GUI of the selected Master Video Effect.

  3. FX PARAM. Use this knob to control the 1st parameter of the selected effect. Hold SHIFT down and use this knob to control the 2nd parameter of the selected effect.

  4. FILTER. Use this knob to apply a Low Pass/High Pass Filter to the deck. In middle position no Filter is applied.

    Hold SHIFT down and use this knob to adjust the key of the track. In middle position the track will have its original value.

  5. LOOP SIZE. Turn the encoder anti-clockwise to half the size of the loop and clockwise to double it. Hold SHIFT down and then use the encoder to move the triggered loop forward or backwards by 1 beat.
    Push the encoder to trigger the selected size loop. Hold SHIFT down and then push the encoder to toggle between normal and Roll Loop mode.

  6. LOOP. Press this button to trigger a loop of the selected size (toggle function).
    When Roll loop mode is selected, the button will apply a temporary (while pressed) Loop Roll and the track will return to the position it would have been if the Loop was never triggered.

Pads