Entra:     

Forum: General Discussion

Topic: Writing Script: Need Help

Questo argomento è obsoleto e potrebbe contenere informazioni obsolete o errate.

Ok this is what I am trying to do..

Basically with each press of the assigned button (no midi controller, this is only at my Laptop key board), I want the following:
1. Bass at Active Deck will graducally reduce by 5%
2. Bass at Default Deck will graducally increase by 5%
3. Bass at Default Deck will eventually increase to 50% and then stop and will not move any higher.

So I write the following script

deck active eq_low -5% & deck default eq_low 50% ? nothing : eq_low +5%

This script does 1 & 2 but not 3. If I keep pressing the assigned key Bass will keep increasing and will not stop at 50%.

Please suggest.

Regards
 
Inviato Fri 12 Nov 10 @ 10:25 pm
any script writers.. please help...
 
Why dont you use the eq-crossfader ?

Try to assign a button as .. eq_crossfader_low +5%
and another one as .. eq_crossfader_low +5%

I think it does the same job

[EDIT] Sorry ..
The correct are ...
eq_crossfader_low +5%
eq_crossfader_low -5%
 
Ok First of all, these 2 commands are exactly same.
I like to achive my desired effect with only 1 button as while mixing I like to keep myself focused with other effect.
Any other suggestions please.
 
Try ..
deck 1 select ? eq_crossfader_low -5% : eq_crossfader_low +5% or the opposite. (+-)
 
thanks however this script plays with EQ Crossfader however I like to play with EQ itself and not the EQ Crossfader.

Anyway It does not do what I set out to do..Thanks though..

Anyone else please
 


(Vecchi argomenti e forum sono automaticamente chiusi)