hardware|denon VIRTUAL DJ SOFTWARE - Hardware Manuals - Denon DJ - MCX-8000 - Layout - Front & Rear

Hardware Manuals


Denon DJ - MCX-8000 - Layout

FRONT & REAR PANELS





  1. POWER: Use the included AC/DC power suplier to connect MCX8000 to a power outlet. While the power is switched off, plug the cable into unit first, and then plug the cable into a power outlet. Use the Power Switch to turn the unit on and off. Turn on unit after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off unit

  2. USB. Connect the unit with a USB port of your computer using the provided USB cable. This USB connection sends and receives audio and control information from a connected computer.

  3. USB HUB. Use the USB HUB socket to connect other USB devices that need to be connected to your computer.

  4. BOOTH OUT (XLR): Use XLR cables to connect this output to a booth monitoring system. The level of this output is controlled by the Booth section on the top panel.

  5. MASTER OUT (Balanced - XLR): Connect this low-impedance XLR output to a PA system or powered monitors. The level of this output is controlled with the Master Level knob on the top panel.

  6. MASTER OUTPUT (RCA): Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the Master Level knob on the top panel.

  7. LINE INPUTS. Connect your audio sources to the 4 available LINE inputs. LINE Inputss 3 and 4 can accept both line and phono-level signals and can be used for DVS as well (see Inputs & Recording. ). Use the PC/ENGINE/LN switches at the top panel to send the audio signal of these Inputs to a Mixer Channel.

  8. MIC 2 Connect a microphone to this input using a 1/4" cable. This input's audio signal is routed directly to the Program Mix and Cue Mix. The Microphone audio signal is controlled from the top panel

  9. MIC 1. Connect a microphone to this input using a 1/4" or XLR cable. This input's audio signal is routed directly to the Program Mix and Cue Mix. The Microphone audio signal is controlled from the top panel
    .
  10. LINK



  11. XFADER CURVE. Adjusts the slope of the crossfader curve. Turn the knob to the left for a smooth fade (mixing) or to the right for a sharp cut (scratching). The center position is a typical setting for club performances.

  12. HEADPHONES SOCKET. Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.