Hardware Manuals


Reloop - Terminal Mix 4 - Layout  

HOTCUES & SAMPLER


This section offers HotCues and Sampler Control and 2 different banks for each one.

  1. BANK Use this button to choose the 1st or the 2nd bank for both HotCues and Sampler. When the led of this button is turned on, the HotCues and Sampler buttons will offer control of the 2nd bank.

  2. HOTCUES 1-4/(5-8). Each one of the 4 HotCue buttons assigns a Hot Cue Point 1 to 4 (or 5 to 8 if the 2nd bank is selected) or returns the track to that Hot Cue Point.
    When a Hot Cue Button is unlit, you can assign a Hot Cue Point by pressing it at the desired point in your track. Once it is assigned, the Hot Cue Button will light up red.
    Hold SHIFT and then press a button to delete its assigned Hot Cue Point. Red leds will blink if a HotCue point exists.

  3. SAMPLES 1-4/(5-8) Each one of the 4 Sampler buttons triggers a sample from the selected Sampler Bank of VirtualDJ8. The buttons will control samples 1 to 4 (or 5 to 8 if the 2nd bank is selected).
    If a bank has less than 9 samples, both sides of the Terminal Mix 4 will control the same samples. If a bank has more than 8 samples, the left side of the Terminal Mix 4 will control samples 1 to 8 and the right side samples 9 to 16.
    The Leds of the Sampler buttons will be turned on if a sampler slot is available (loaded) and will blink is triggered.

    Press the buttons to trigger a sample. Depending on the selected trigger mode, use SHIFT and the same pads to stop the sample.
Mixer & Browser