MIC/AUX: Select if using the Mic (62) input (switch towards left) or the Aux (46) input (switch towards right). Center position turns the Mic/Aux Input off.
AUX INPUT: Additional Aux input for connecting various Line signal sources, controlled via the MIC/AUX (47) knob.
MIC/AUX LEVEL: Adjust the level of the Mic (62) or Aux (46) input.
MIC/AUX TONE ADJUST: Adjust the tone of the Mic (62) or Aux (46) input.
MIC ECHO: Adjust the Echo effect of the Mic input. (Please note that Echo Effect is a hardware effect and it cannot be adjusted/altered through VirtualDJ).
CROSSFADER REVERSE: Reverses the Left with the Right Channel control on the Crossfader (1).
CROSSFADER CURVE: Adjust the Crossfader curve from Hard (towards right) to Soft (towards left).
HEADPHONES MIXING: Use this knob to blend in Headphones the audio signal from the Master Output and the Decks that are sent to Headphones Channel via the CUE/PFL buttons (3). When the knob is at the minimum position, only the Decks that have been selected with the CUE/PFL buttons (at the top panel) will be heard in Headphones. When the same knob is at the maximum (right) position, the signal from the Master Output will be heard in Headphones.
HEADPHONES VOLUME: Adjust the headphones output volume.
SPLIT CUE: If enabled, the headphones signal gets split: Master signal on one channel, and the enabled Cue signals selected via the CUE/PFL buttons (3) on the other channel.
HEADPHONES CONNECTORS: Connect your headphones. Both sizes (3.5mm and 6.35mm ( 1⁄4 in)) are offered.
BOOTH OUTPUT: Booth signal output (TRS – Balanced). The strength of the signal is controlled by BOOTH LEVEL knob (11) on the mixer section. Use it to connect your booth speakers, or an amp that needs different sound output level than master output.
MASTER OUT1: Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers.
MASTER OUT2: Master signal output connectors (RCA – Unbalanced). Use it to connect with another mixer, or consumer grade amplifier.
CH2 INPUT: Connect an analog source on CH2 of the Mixars Primo mixer. You can connect a turntable or a CD-Player. The input is selectable via the INPUT SELECT SWITCH (9) on the mixer section. Please note that depending on whether you connect a CD player or a turntable you also need to adjust the phono/line switch for the input.
GND SCREW: Use it to screw your GND (ground) cable from turntables that provide it in order to eliminate GND static noise.
CH1 INPUT: Connect an analog source on CH1 of the Mixars Primo mixer. You can connect a turntable or a CD-Player. The input is selectable via the INPUT SELECT SWITCH (9) on the mixer section. Please note that depending on whether you connect a CD player or a turntable you also need to adjust the phono/line switch for the input.
MIC INPUT: Connect a mic on the Mixars Primo mixer. You can use XLR or Jack (TRS) connectors.
USB CONNECTOR: Use a standard USB cable to connect Mixars Primo with your computer.
POWER SWITCH: Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.
