dasdadd
Okay, strange issue.....
**My setup**
MB-PRO
Digidesign Mbox Pro (Firewire)
X-Session (USB)
In VDJ6 I created a customer map for my X-session and it worked fine (after alot of mapping work)
In VDJ7 i would load up. the controller works for the first few secs (10 or so) then it stops working.
Troubleshooting i have done
Rescan for devices while in VDJ7: X-session is found but continue not to work. Also, when i leave the config page and come back, it is gone again.
Check for drivers, X-session does not require any drivers with OSX. (So this is okay)
Created a new account in OSX, and reinstall VDJ7 (No luck)
Not really sure what else i can do.
I would like to update since i find the audio is better on VDJ7 but i am forced to use VDJ6.
any ideas?
**My setup**
MB-PRO
Digidesign Mbox Pro (Firewire)
X-Session (USB)
In VDJ6 I created a customer map for my X-session and it worked fine (after alot of mapping work)
In VDJ7 i would load up. the controller works for the first few secs (10 or so) then it stops working.
Troubleshooting i have done
Rescan for devices while in VDJ7: X-session is found but continue not to work. Also, when i leave the config page and come back, it is gone again.
Check for drivers, X-session does not require any drivers with OSX. (So this is okay)
Created a new account in OSX, and reinstall VDJ7 (No luck)
Not really sure what else i can do.
I would like to update since i find the audio is better on VDJ7 but i am forced to use VDJ6.
any ideas?
Inviato Tue 02 Nov 10 @ 10:07 pm
dasdadd
I have corrected the issue with VDJ6
I had to reinstall OSX from scratch.
as for VDJ7 the issue continues.
any ideas ?
I had to reinstall OSX from scratch.
as for VDJ7 the issue continues.
any ideas ?
Inviato Wed 03 Nov 10 @ 9:50 pm