dejaymikek
For anyone out there that has this controller can you tell me if the built-in stems work with Virtual DJ software? I'm thinking about getting this controller. Thank you
Inviato Thu 13 Jun 24 @ 3:43 pm
kradcliffe
It's the other way round, but yes stems work in conjunction with the controller assuming your PC is powerful enough.
Inviato Thu 13 Jun 24 @ 4:16 pm
xXCpt_NemoXx
I do own this and they do work. Personally I find this controller to be a lot of fun as having four channels combined with stem splitting opens a whole new world of possible transitions and mixing.
Inviato Thu 13 Jun 24 @ 7:30 pm
dejaymikek
Do I need to download anything additionally to make it work (pioneer ddx-flx10) or will the controller work on it's own?
Inviato Thu 13 Jun 24 @ 8:43 pm
xXCpt_NemoXx
So your controller (FLX10) controls the software (VirtualDJ) that is what does the stem separation. VirtualDJ has system requirements that determine if stems will work or not. Refer to https://www.virtualdj.com/wiki/Minimum+system+requirements.html > "Additional for stems 2.0" for more info.
Inviato Thu 13 Jun 24 @ 8:47 pm
djdad
dejaymikek wrote :
Do I need to download anything additionally to make it work (pioneer ddx-flx10) or will the controller work on it's own?
Check if firmware is updated to the latest version and also install the driver
https://www.virtualdj.com/manuals/hardware/pioneer/ddjflx10/setup.html
Inviato Thu 13 Jun 24 @ 8:51 pm
dejaymikek
Does the stems 2.0 virtual dj drivers need to be added also or will it work just from the pioneer controller alone?
Inviato Mon 17 Jun 24 @ 6:11 pm
kradcliffe
The stems are calculated within VirtualDJ and are nothing to do with the controller.
Inviato Mon 17 Jun 24 @ 6:32 pm
xXCpt_NemoXx
There is no driver for VirtualDJ stems. VirtualDJ comes with the ability to do stem separation already included. Whether or not it can be done without the stems having been prepared in advance or if it can be done as soon as the track loads while it is playing depends purely on the capabilities of your computer hardware.
Inviato Wed 19 Jun 24 @ 8:26 pm
dejaymikek
Since you have this controller does the stems commands work properly on this controller? Thanks for your help.
Inviato Thu 20 Jun 24 @ 3:01 pm
xXCpt_NemoXx
I mean it really depends on what you mean by that. They do work in the most basic sense of the default mapping can control stems. So yes, they work and if they don't in a way you need them too then very often it is possible to script your own solution.
Inviato Fri 21 Jun 24 @ 3:54 am