Hardware Manuals


Denon DJ - MC-6000 MKII - Layout  

Pannello Posteriore





  1. POWER: Use the included power adaptor to connect MC6000MKII to a power outlet. While the power is switched off, plug the cable into MC6000MKII first, and then plug the cable into a power outlet. Use the Power Switch to turn the MC6000MKII on and off. Turn on MC6000MKII after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off MC6000MKII.

  2. USB. This USB connection sends and receives audio and control information from a connected computer.

  3. USB AUDIO MODE. Define how the Inputs of the MC6000MKII audio interface are routed to the computer. See Advanced Audio Setup

  4. BOOTH OUTPUT (BALANCED): Use standard TRS cables to connect this output to a booth monitoring system. The level of this output is controlled by the Booth knob on the top panel.

  5. MASTER OUTPUT (XLR): Connect this low-impedance XLR output to a PA system or powered monitors. The level of this output is controlled with the Master knob on the top panel.

  6. MASTER OUTPUT (RCA): Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the Master knob on the top panel.

  7. LINE INPUTS. Connect your audio sources to these inputs. Inputs 1 and 2 can accept both line and phono-level signals.

  8. MIC 2 INPUT. Connect a 1/4" microphone to this input. Microphone controls are located on the top Microphone panel.

  9. MIC 1 INPUT. Connect a 1/4" microphone to this input. Microphone controls are located on the top Microphone panel.