Hardware Manuals


Rane - One - Layout  

MIXER & EFFECTS





KEY

ACTION

1 CROSSFADER
Blends audio between left and right mixer channels
2 VOLUME
Adjust the Volume of each mixer channel.
3 * CUE
Select which Chanel/Deck will be sent to Headphones output for pre-listening. Press both buttons simultaneously to send both Decks to Headphones
4 FX ON/LOCK
Enable/disable the armed Effects on Left/Right Deck. Move paddle to upper position to lock (toggle) or to lower position (and hold) for temporary triggering
5 FX1-FX6 ARM
Select the Effect Slots 1 to 6 you wish to arm/prepare and enable/disable using the FX ON paddles. The selection of the Effects in Slots 1 to 6 are done from VirtualDJ GUI. It is advised to have the 6FX Slots panel visible
6 FX TAP
No function (Not assigned)
7 FX DEPTH
Adjust the 1st Parameter (usually Dry/Wet) of the Effects of all 6 FX Slots in both Left/Right Decks simultaneously
8 FX BEATS
Adjust the Beats Parameter of the Effects of all 6 FX Slots in both Left/Right Decks simultaneously.
Push to set Beats Effect Parameter to 1 beat
9 LP/HP FILTER
Apply a Low/High-pass Filter to left/right mixer channel. When centered, no Filter is applied.
10 EQ
Adjust the low (bass), mid (middle) and high (treble) frequencies of left/right mixer channel.
Stems Equalizer modes are fully offered See Modern Equalizer
11 LEVEL
Adjusts the pre-fader audio level (gain) of left/right mixer channel.
12 SOURCE SELECT
Select the input source of Left/Right mixer channel. Put the switchers to USB A or USB B position for sending Left/Right VirtualDJ Deck to Left/Right mixer channels.
Set to LINE to route the audio signal of the Auxiliary LINE inputs(connections at the rear panel) to Left/right mixer Channels.VirtualDJ Decks will be muted in this case.
See further details in Advanced Setup
13 * MAIN LEVEL
Adjusts the volume of the Master output of the device (connection at the rear panel).
14 * BOOTH LEVEL
Adjusts the volume of the Booth output of the device (connection at the rear panel).



* Please note that these controls are hardware operated, but their movement/positions will be visible in VirtualDJ GUI.
Controlli del lettore