REAR PANELS

Gemini PMX20 - Rear panel

CONTROL

ACTION

32 POWER

Connect PMX20 to an AC socket and power on when all other connections are done

33 MASTER XLR

Balanced Master Output. Connect your amplifier (or a pair of amplified speakers) to this output using standard XLR cables. The level of this output is controlled by the MASTER VOL knob at the top panel

34 MASTER RCA

Alternative unbalanced Master Output. Connect your amplifier (or a pair of amplified speakers) to this output using standard RCA cables. The level of this output is controlled by the MASTER knob at the top panel

35 BOOTH

Secondary unbalanced Output. Connect your amplifier (or a pair of amplified speakers) to this output using standard RCA cables. The level of this output is controlled by the BOOTH knob at the top panel

36 REC

Recording unbalanced Output. Connect a Recording device to this output to record your mix

37 USB

Connect this socket to a USB port of your computer using standard USB cable to allow your computer software to receive and send data to the PMX20

38 CH1 to CH4 Inputs

Connect your analogue sources/devices to these sockets. The audio signal of these sources will be routed to the Master Output in the following cases.
- VirtualDJ (or other supported application) is not running (stand-alone)
- VirtualDJ is running, the PMX20 is set to Hardware (Mixer) mode and the USB buttons are turned off
- VirtualDJ is running with Timecode inputs set in Audio Setup (signal of the Timecode sources) will be muted from output and will be routed to VirtualDJ for DVS control.

39 PH/LN

Set these switchers to PH position if you have connected devices to the CH1-CH4 inputs respectively, without pre-amp such as Turntables. Set to LN position in other cases.

40 MIC IN

Connect a Microphone to this input, using XLR or 1/4" cable/adapter. The level of the Microphone audio signal is controlled from the MIC LEVEL knob at the top panel. Note that this input is not part of the USB Audio interface, thus the Microphone of the PMX20 cannot be included in the VirtualDJ Audio setup, nor can be controlled or recorded.

41 EFFECT SEND/RETURN

Use these sockets to connect an external Audio Effect generator device, to receive audio signal from the PMX20 channel (when the FX SEND button is enabled) and return its processed signal adjusted by the RETURN knob at the top panel.
This procedure is not operated by VirtualDJ

Setup Avanzato